Is it correct to have DIFFERENT VALUES of renderding points following a BRAKE TEST carried out by ship staff on board a tanker . To note that MBL of all wires put in place is 50.6 Ts.

asked 10 Jul, 03:56

OPSSHIP22's gravatar image

accept rate: 0%

The brake rendering point must be set to 60% of the rope's MBL (Minimum Break Load). In your case, all ropes have the same MBL which means corresponding winches rendering points to be set to the same value of 60% of the rope's MBL equal to 30.36 TS.

permanent link

answered 10 Jul, 16:38

marinexpert's gravatar image

accept rate: 0%

add your answer

MarineProHelp 2018.