VARNISH

Method of lubricating moving parts by agitating or splashing oil in the crankcase.

A support or guide by means of which a moving part such as a shaft or axle is positioned with respect to the other parts of a mechanism.

Additive for protecting lubricated metal surfaces against chemical attack by water or other contaminants. There are several types of corrosion inhibitors. Polar compounds wet the metal surface preferentially, protecting it with a film of oil. Other compounds may absorb water by incorporating it in a water-in-oil emulsion so that only the oil touches the metal surface. Another type of corrosion inhibitor combines chemically with the metal to present a non- reactive surface.

Improves the service life of tribological elements operating in the boundary lubrication regime. Anti-wear compounds (for example, ZDDP and TCP) start decomposing at 90° to 100°C and even at a lower temperature if water (25 to 50 ppm) is present.

A heavy residual lubricant stock with low pour point, used in finished blends to provide good bearing film strength, prevent scuffing, and reduce oil consumption. Usually identified by its viscosity, SUS at 210°F or cSt at 100°C.

In rolling element bearings, the elastic deformation of the bearing (flattening) as it rolls, under load, in the bearing race. This momentary flattening improves the hydrodynamic lubrication properties by converting point or line contact to surface-to-surface contact.

A rolling contact type bearing in which the rotating or moving member is supported or guided by means of ball or roller elements. Does not mean without friction.

microscopic projections on metal surfaces resulting from normal surface-finishing processes. Interference between opposing asperities in sliding or rolling applications is a source of friction, and can lead to metal welding and scoring. Ideally, the lubricating film between two moving surfaces should be thicker than the combined height of the opposing asperities.

Form of lubrication between two rubbing surfaces without development of a full-fluid lubricating film. Boundary lubrication can be made more effective by including additives in the lubricating oil that provide a stronger oil film, thus preventing excessive friction and possible scoring. There are varying degrees of boundary lubrication, depending on the severity of service. For mild conditions, oiliness agents may be used; by plating out on metal surfaces in a thin but durable film, oiliness agents prevent scoring under some conditions that are too severe for a straight mineral oil. Compounded oils, which are formulated with polar fatty oils, are sometimes used for this purpose. Anti-wear additives are commonly used in more severe boundary lubrication applications. The more severe cases of boundary lubrication are defined as extreme pressure conditions; they are met with lubricants containing EP additives that prevent sliding surfaces from fusing together at high local temperatures and pressures.

A system of lubrication in which the shape and relative motion of the sliding surfaces causes the formation of a fluid film having sufficient pressure to separate the surfaces.