Get help from Pros. Remove ads. Promote your CV or LinkedIn profile.
The calculated constant radial load (thrust load for thrust bearings) which a group of identical bearings with stationary outer rings can theoretically endure for rating life of 1 million revolutions of inner ring.

Related Terms

False brinelling

False brinelling of needle roller bearings is actually a fretting corrosion of the surface since the rollers are the I.D. of the bearing. Although its appearance is similar to that of brinelling, false brinelling is characterized by attrition of the steel, and the load on the bearing is less than that required to produce the resulting impression. It is the result of a combination of mechanical and chemical action that is not completely understood, and occurs when a small relative motion or vibration is accompanied by some loading, in the presence of oxygen.

AXIAL-LOAD BEARING

A bearing in which the load acts in the direction of the axis of rotation.

EP (EXTREME PRESSURE) LUBRICANTS

Lubricants that impart to rubbing surfaces the ability to carry appreciably greater loads than would be possible with ordinary lubricants without excessive wear or damage.

BRINELLING

Permanent deformation of the bearing surfaces where the rollers (or balls) contact the races. Brinelling results from excessive load or impact on stationary bearings. It is a form of mechanical damage in which metal is displaced or upset without attrition.

LOAD-CARRYING CAPACITY

Property of a lubricant to form a film on the lubricated surface, which resists rupture under given load conditions. Expressed as maximum load the lubricated system can support without failure or excessive wear.

TIMKEN OK LOAD

The heaviest load that a test lubricant will sustain without scoring the test block in the Timken Test procedures, ASTM Methods D 2509 (greases) and D 2782 (oils).

PIVOT BEARING

An axial load bearing, radial-load-type bearing which supports the end of a shaft or pivot.

ELECTRICAL CIRCUIT

A power supply, a load, and a path for current flow are the minimum requirements for an electrical circuit.

DYNAMIC CREEP

Creep that occurs under conditions of fluctuating load or fluctuating temperatures.

LOAD

The amount of heat per unit time imposed on a refrigeration system or the required rate of heat removal.
Get help from Pros. Remove ads. Promote your CV or LinkedIn profile.

Related questions

MarineProHelp 2018 - 2022