Get help from Pros. Remove ads. Promote your CV or LinkedIn profile.
International Load Line Convention

Related Terms

RESTRICTOR

A device for producing a deliberate pressure drop or resistance in a line by reducing the cross-sectional flow area.

GRID RHUMB LINE

A line making the same oblique angle with all grid meridians. Grid parallels and meridians may be considered special cases of the grid rhumb line.

HALF-POWER POINTS

Power ratios used to define the angular width of a radar beam. One convention defines beam width as the angular width between points at which the field strength is 71 percent of its maximum value. Expressed in terms of power ratio, this convention defines beam width as the angular width between half-power points. A second convention defines beam width as the angular width between points at which the field strength is 50 percent of its maximum value. Expressed in terms of power ratio, the latter convention defines beam width as the angular width between quarter- power points.

HAND LEAD

A light sounding lead (7 to 14 pounds), usually having a line of not more than 25 fathoms

GROUND LOG

A device for determining the course and speed over the ground in shallow water consisting of a lead or weight attached to a line. The lead is thrown overboard and allowed to rest on the bottom. The course over ground is indicated by the direction the line tends and the speed by the amount of line paid out in a unit of time.

False brinelling

False brinelling of needle roller bearings is actually a fretting corrosion of the surface since the rollers are the I.D. of the bearing. Although its appearance is similar to that of brinelling, false brinelling is characterized by attrition of the steel, and the load on the bearing is less than that required to produce the resulting impression. It is the result of a combination of mechanical and chemical action that is not completely understood, and occurs when a small relative motion or vibration is accompanied by some loading, in the presence of oxygen.

AXIAL-LOAD BEARING

A bearing in which the load acts in the direction of the axis of rotation.

CASE DRAIN FILTER

A filter located in a line conducting fluid from a pump or motor housing to reservoir.

ELASTOHYDRODYNAMIC LUBRICATION

In rolling element bearings, the elastic deformation of the bearing (flattening) as it rolls, under load, in the bearing race. This momentary flattening improves the hydrodynamic lubrication properties by converting point or line contact to surface-to-surface contact.

EP (EXTREME PRESSURE) LUBRICANTS

Lubricants that impart to rubbing surfaces the ability to carry appreciably greater loads than would be possible with ordinary lubricants without excessive wear or damage.
Get help from Pros. Remove ads. Promote your CV or LinkedIn profile.

Related questions

MarineProHelp 2018 - 2022